■ Logo file (CAD file) : CDF
Sets the logo file.
Setting / Readout data of logo file
STX
CDF
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.
Readout request of logo file
STX
CDF
Data length
Name
[byte]
CAD No.
CAD file name
Max. 8
Reference
• Logo file for the LP-F series is treated as one for LP-F10/F10W (marking area 90 mm x 90 mm). Logo file used for
special-order model (marking area other than 90 mm x 90 mm) is not supported.
• The CAD No. 16 and after cannot be set and read out. (NAK09 is returned.)
• The long file name and DXF file name cannot be specified. (NAK09 is returned.)
If readout is performed when long file name and DXF file name are specified, NAK15 is returned.
• If readout data includes characters that cannot be expressed in ASCII code such as Katakana and Kanji (2-byte
character), these 2-byte characters are read out in shift-JIS code.
146
Sub
[CAD No.] [CAD file name]
Max. 10-byte
[CAD No.]
R
2-byte
Description
2
"00"–"15"
When the file name is "ABCD.VEC":
"ABCD".
(Check sum)
(Check sum)
Delimiter
The CAD file name corresponding to the
specified number is indicated without extension.
The CAD file specification will be deleted unless
the file name is specified.
ME-LPMSZ-SR-9
Delimiter
Remarks