Panasonic LP-M Series Serial Communication Manual page 150

Data length
Name
[byte]
X position 7
Y position 7
Character
6
interval
Line interval 6
Font No. 1
Bold line width 5
Laser power
3
correction
Scan speed
3
correction
Laser pulse
(3)
cycle correction
* For the detail of the model type, refer to "Target laser marker" (P.4).
2. When markings from is slope/slope proportional
Data length: 66-byte (LP-F10 mode), 63-byte (LP-F10W mode)
Data length
Name
[byte]
Character
condition No.
Start line
End line
Marking shape
150
Description
Model type*
LP-Sxx0(W)
LP-Sxx5(W)
LP-Sxx2
LP-Mxx0/LP-Zxx0 "-060.00"–"+060.00"
LP-Mxx5
LP-Mxx6/LP-Zxx6
Model type*
LP-Sxx0(W)
LP-Sxx5(W)
LP-Sxx2
LP-Mxx0/LP-Zxx0
LP-Mxx5
LP-Mxx6/LP-Zxx6
"1": Font 1
"2": Font 2
• LP-F10 Mode
"-00.00"–"01.92" [mm]
• LP-F10W Mode
Model type*
LP-Sxx0(W)/LP-Sxx2/
LP-Mxx0/LP-Zxx0
LP-Sxx5(W)/LP-Mxx5/
LP-Mxx6/LP-Zxx6
"000"–"200" [%]
"050"–"200" [%]
"050"–"200" [%]
(LP-F10 mode only)
Description
2 "01"–"30"
2 "01"–"30" [row]
2 "01"–"30" [row]
"1": Slope
1
"5": Slope proportional
Setting range [mm]
"-045.00"–"+045.00"
"-080.00"–"+080.00"
X, Y coordinate where the first character
"-027.50"–"+027.50"
is marked is indicated.
"-110.00"–"+110.00"
"-165.00"–"+165.00"
Setting range [mm]
Indicates the gap between adjacent
"000.00"–"090.00"
characters.
"000.00"–"160.00"
"000.00"–"055.00"
"000.00"–"120.00" The line pitch to mark the next line is
indicated when the character string is
"000.00"–"220.00"
marked over two or more lines.
"000.00"–"330.00"
The number corresponding to the 2 fonts
previously registered is indicated.
Setting range [mm]
"00.00 –"02.00
" "
"00.00 –"03.20
" "
• The correction ratio is calculated using
• Laser Pulse Cycle Correction can be
The start and end line of character
string for marking with this condition is
indicated.
When the tilt angle is set to 0 degree,
this item is readout as "0" (straight line)
or "4" (straight line proportional).
ME-LPMSZ-SR-9
Remarks
the value set at the laser condition as
100%.
specified only in LP-F10 mode.
Remarks