Marking Quality Adjustment: Wtc; Setting / Readout Data Of Marking Quality Adjustment - Panasonic LP-M Series Serial Communication Manual

■ Marking quality adjustment: WTC

Sets laser start point, end point, edge and curve adjustments, etc.

Setting / Readout data of marking quality adjustment

STX WTC
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.
Readout request of marking quality adjustment
STX WTC
Data length
Name
Adjustment of
starting point
Adjustment of
ending point
Edge adjustment
Curve adjustment
Waiting time
Pre-scan time
Jump adjustment
Point radiation ON
Point radiation
OFF
* Only one of [Point radiation ON] and [Point radiation OFF] cannot be omitted. (Response is not omitted.)
When setting arbitrary point radiation ON/OFF adjustment, jump adjustment is not omissible.
100
[Adjustment of starting point] [Adjustment of ending point]
[Edge adjustment] [Curve adjustment] [Waiting time]
Sub
[Pre-scan time] [Jump adjustment]
[Point radiation ON] [Point radiation OFF]
R (Check sum)
Description
[byte]
4 "-100"–"+100"
4 "-100"–"+100"
3 "000"–"100"
3 "000"–"100"
3 "000"–"100"
5 "00.00"–"10.00" [ms]
(3) "000"–"100"
(4) "0.00"–"9.99" [ms]
(4) "0.00"–"9.99" [ms]
Max. 33-byte
Delimiter
The timing of starting laser is adjusted.
The timing of stopping laser is adjusted.
The wait at edge is adjusted.
The wait at curved line is adjusted.
The waiting time is adjusted.
The pre-scan time is adjusted.
The correction value of galvano jump is adjusted.
(omissible)
The timing of the point radiation ON is adjusted.
(omissible *)
The timing of the point radiation OFF is adjusted.
(omissible *)
ME-LPMSZ-SR-9
(Check
Delimiter
sum)
Remarks