Response To Readout Designation Of Power Check Result - Panasonic LP-M Series Serial Communication Manual

Response to readout designation of power check result

STX PWR
Data length
Name
[byte]
Current power
Power after
correction
Power
correction ratio
Correction date 14
Total laser
radiation time
Determination
(Applicable only (1)
LP-SxxxW)
Reference
• Power correction refers to the function to correct not the max. laser power [W] value but the laser power setting value.
Power correction does not change the actual max. output power relative to initial power.
108
[Current power] [Power after correction]
[Power correction ratio] [Correction date]
A
[Total laser radiation time] [Determination]
33-byte (LP-SxxxW), 32-byte (LP-Zxxx)
Content
3 "000"–"xxx"
3 "000"–"xxx"
5 "050.0"–"200.0" [%]
For 15:00:00 on April 1, 2012
"20120401150000"
9 "0000000.0"–"1000000.0" [h]
"0": Correct
"1": Lower than the "Low Power
Detect Level".
Indicates the current power ratio [%] in comparison
with the default laser power.
• The value obtained by multiplying the current
power by the power correction ratio is indicated.
It may differ from the calculated value depending
on the correction ratio.
• When the power correction has not been
performed, this value is "000".
When the power correction has not been performed,
this value is "000".
When the power correction has not been performed,
this value is "00000000000000".
It is indicated whether or not the power check result
is lower than the value set in "Low Power Detect
Level".
This result is valid only in the measurement result
readout just after the start point of the power check.
(Not transmitted for LP-Zxxx.)
ME-LPMSZ-SR-9
(Check sum) Delimiter
Remarks