Line Speed: Lsp; Setting / Readout Data Of Line Speed; Readout Request Of Line Speed; Encoder Signal: Enc - Panasonic LP-M Series Serial Communication Manual

■ Line speed: LSP

[Supported models: LP-Mxxx / LP-Sxxx / LP-Zxxx]
Sets the line speed in flying object marking.

Setting / Readout data of line speed

STX LSP
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.

Readout request of line speed

STX LSP
Data length
Name
Line speed
* For the detail of the model type, refer to "Target laser marker" (P.4).

■ Encoder signal: ENC

[Supported models: LP-Mxxx / LP-Sxxx / LP-Zxxx]
Sets the encoder pulse value for use of the encoder in flying object marking.
Setting / Readout data of encoder signal
STX ENC
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.
Readout request of encoder signal
STX ENC
Data length
Name
Encoder pulse
Reference
• The setting changed by this command is saved without overwriting.
104
Sub [Line speed]
7-byte
R (Check sum)
[byte]
Model type*
LP-Sxx0/LP-Sxx5
LP-Mxx6/LP-Sxx2/
7
LP-Z256
LP-Mxx0/LP-Mxx5/
LP-Zxx0
Sub [Encoder pulse]
6-byte
R (Check sum)
Description
[byte]
6 "005.00"–"600.00" [Pulse/mm]
(Check sum)
Delimiter
Description
Setting range [m/min]
"000.060"–"240.000"
"000.060"–"120.000"
"000.060"–"170.000"
(Check sum)
Delimiter
Available only when the moving direction is
other than "still".
ME-LPMSZ-SR-9
Delimiter
Remarks
The speed with which the object
to be marked passes is indicated,
available only when the traveling
direction is other than "still" and
encoder signal is "OFF".
Delimiter
Remarks