External Offset - Panasonic LP-M Series Operation Manual

2-9-5 External Offset

The external offset is the function for varying character string using I/O control by inputting coordinate data corresponding
to I/O connector No (D0 to D15) beforehand. Refer to "Rank Offset Marking" of "Safety / Setup / Maintenance Guide" for
control method with I/O.
Reference
External offset function cannot be used in combination with the following functions.
• Serial Date Marking (Except when "Serial Data" is set to the external offset condition)
• Equidistant marking to flying object
• 3D Marking (Only LP-M / LP-Z Series)
1
2
Description
1 External Offset :
Sets the input condition for the I/O connector No. (D0 to D15).
Setting Range
2 Parallel Value (Parallel Input Value) :
Enables to check offset image of the parallel input value input beforehand. The coordinate with this parallel input
value input here displays as the coordinate for check on the image display screen.
Setting Range
126
3 4
Not use : If you do not use the offset function, specify these values.
Enables to set data for 1024 offset values from 0 to 1023 with the low 10 bit
Low 10 bit :
(D0 to D9) as the one marking coordinate table.
Enables to set data for 256 offset values from 0 to 255 with the low 8 bit (D0
Low 8 bit :
to D7) as the one marking coordinate table.
Enables to set data for 16 offset values from 0 to 15 with the low 4 bit (D0 to
Low 4 bit :
D3) as the one marking coordinate table.
The offset value is specified by the communication command "SEO". For
Serial Data :
communication commands, refer to Serial Communication Guide.
In the case that the external offset condition is Low 10 bit
In the case that the external offset condition is Low 8 bit
In the case that the external offset condition is Low 4 bit
5 6
ME-LPMSZ-OP-7
: 0 to 1023
: 0 to 255
: 0 to 15