File No. Change: Fno; Setting / Readout Data Of File No.; Readout Request Of File No. - Panasonic LP-M Series Serial Communication Manual

■ File No. change: FNO

Specifies the file No. to change the file.

Setting / Readout data of file No.

STX FNO
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.

Readout request of file No.

STX FNO
Data length
Name
[byte]
File No.
Reference
• The file Nos. 256 and after cannot be specified. (NAK09 is returned.)
NAK15 is returned when the readout was performed with the file No. 256 to 2047.
• When new file is created using the communication command, initialize the kerning level to Level 2.
(If the file is newly created using the console, initialize the kerning level to Level 3.)
• When new file is created using the communication command with LP-F10W mode, the laser pulse cycle is set to the
minimum value as an initial setting.
■ File overwriting registration: FOR
Overwrite the file currently being edited over the file selected.
Overwriting is possible when the file has been already determined.
Overwriting of file
STX FOR
126
Sub [File No.]
3-byte
R (Check sum)
Description
"000"–"255"
3
"999": New file
S (Check sum)
(Check sum)
Delimiter
The file number to be used and the file number
currently being used is indicated at file No.
change and readout of file No. respectively.
Delimiter
ME-LPMSZ-SR-9
Delimiter
Remarks