2D Code Pattern: Brp; Setting / Readout Data Of 2D Code Pattern; Readout Request Of 2D Code Pattern - Panasonic LP-M Series Serial Communication Manual

■ 2D code pattern: BRP

Sets 2D code module marking pattern.

Setting / Readout data of 2D code pattern

STX BRP
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.

Readout request of 2D code pattern

STX BRP
Name
Bar code No.
Pattern type
Character code
Laser power correction
Scan speed correction
(Laser pulse cycle
correction)
70
[Bar code No.] [Pattern type] [Character code]
Sub [Laser power correction] [Scan speed correction]
[Laser pulse cycle correction]
16-byte (LP-Mxxx / LP-Sxxx / LP-Zxxx), 13-byte (LP-SxxxW)
[Bar code No.] [Pattern No.]
R
3-byte
Data length
[byte]
2 "00"–"15"
• QR code:
"0": Margin
"1": Dark Module
"2": Light Module
"3": Alignment
1 "4": Finder
• Data Matrix code:
"0": Quiet Zone:
"1": Mark Module
"2": Space Module
"3": Border
"0000", "2230"–"2239" or
4
"8121"–"8152"
3 "000"–"999" [%]
3 "001"–"999" [%]
(3) "001"–"999" [%]
(Check sum)
Description
Specifies the character code to be used
as a pattern in JIS code. Set "0000" to
no marking pattern. However, when the
alignment finder pattern of the QR code
is set to "0000", marking is performed
using the dark/light module, and when the
Data Matrix code border is set to "0000",
marking is performed using the mark
module.
• The correction ratio is calculated using
• With LP-SxxxW type, nothing should be
ME-LPMSZ-SR-9
(Check
sum)
Delimiter
Remarks
the value set at the laser condition as
100%.
input in Laser Pulse Cycle Correction.
Delimiter