Bar Code Marking Condition: Brf; Qr Code - Panasonic LP-M Series Serial Communication Manual

■ Bar code marking condition: BRF

Sets the marking condition for bar code and 2D code.
Setting / Readout data of bar code marking condition
STX BRF
command
Sub command is "S" at the time of setting and "A" for response data at the time of readout.
Readout request of bar code marking condition
When the code type is other than composite:
STX BRF
When the code type is composite:
STX BRF
In [1D/2D Selection] field, specify "1" for readout of 1D side or "2" for readout of 2D side of composite code.
1. QR code (Data length: 44-byte)
Data length
Name
Bar code No.
Layer No.
Code type
System
reservation
Version
Data input mode
Error correction
level
X position
Y position
Rotation angle
Module H.
Module W.
* For the detail of the model type, refer to "Target laser marker" (P.4).
58
Sub [Bar code No.] [Layer No.] [Code type]
[Setting data (varies depending on bar code type)]
[Bar code No.]
R
2-byte
[Bar code No.] [1D/2D selection]
R
3-byte
[byte]
2 "00"–"15"
2 "00"–"15"
"10": Model 1
2 "11": Model 2
"12": Micro QR code
1 "0" fixed
Model 1: "00"–"14"
2 Model 2: "00"–"22"
Micro QR: "00"–"04"
"0": Number
"1": Alpha (text)
1
"2": Binary
"3": Kanji
"0": L
"1": M
1
"2": Q
"3": H
Model type*
8
LP-Sxx0(W)
LP-Sxx5(W)
LP-Sxx2
LP-Mxx0 / LP-Zxx0
8
LP-Mxx5
LP-Mxx6/LP-Zxx6
7 "-180.00"–"+180.00" [°]
5
"0.001"–"9.999" [mm]
5
(Check sum)
(Check sum)
Description
Setting range [mm]
"-045.000"–"+045.000"
"-080.000"–"+080.000"
"-027.500"–"+027.500"
"-060.000"–"+060.000"
"-110.000"–"+110.000"
"-165.000"–"+165.000"
ME-LPMSZ-SR-9
(Check sum)
Delimiter
Delimiter
Remarks
When specifying "00", it is
automatically specified.
For micro QR, Error Correction
Level "H" cannot be used.
Specifies the center coordinate of
the code.
Interval of module in longitudinal
direction.
Interval of module in lateral direction
Delimiter