Shift To Remote Mode; Use The Remote Switch On The Front Of The Controller; Start The Laser Marker In The Remote Mode - Panasonic LP-M Series Serial Communication Manual

1-2-3 Shift to remote mode

To control the laser marker externally using I/O or serial communication commands, set the operation mode to the remote
mode in one of the following methods.
Select the method to switch to the remote mode by setting the DIP switch on the rear side of the controller.

Use the remote switch on the front of the controller.

Turn ON the remote mode switch on the front of the controller.
Use input signal of X5 "REMOTE IN" on I/O terminal.
Turn ON the remote mode input (X5) of the I/O terminal on the rear of the controller.
Reference
• When DIP switch No. 5 is ON, the remote switch on the controller is not available.

Start the laser marker in the remote mode

The laser marker starts up always in the remote mode state. Use the remote mode switch button of the controller for
releasing and resetting the remote mode.
OFF
ON
Reference
• When DIP switch No. 6 is ON, "X5: REMOTE IN" signal on I/O terminal is not available.
• The remote switch on the controller is available when DIP switch No. 6 is ON.
X5: REMOTE IN
ME-LPMSZ-SR-9
Turn OFF the DIP switch No. 5.
Refer to "1-2-1 DIP switch setting" (P.12).
Turn ON the DIP switch No. 5.
Refer to "1-2-1 DIP switch setting" (P.12).
Turn OFF the DIP switch No. 5 and turn ON the DIP
switch No. 6.
Refer to "1-2-1 DIP switch setting" (P.12).
15