Logo Condition - Panasonic LP-M Series Operation Manual

2-10-3 Logo Condition

„ VEC File Format
1
2
3
14
6
7
15
8
Description
1 Logo No. :
Registered No. of logo data to be marked. Max. 100 logo files are settable for per file.
Setting Range
2 File Format :
Selects file format from "VEC" or "DXF".
3 Logo File :
Displays the logo file set to the specified logo No. The selecting window for logo file is appeared by pressing logo
file name. Select the logo file to be marked, and press [SET].
Reference
• The max. loadable coordinate is 131,072 points.
The number of coordinate points can be checked in "Logo Data Conversion Software".
• Compared to the VEC file, the data amount of the DXF file becomes heavier and its time to be in READY for marking
will be longer.
In case of registering much logo data or shortening the time for file change, convert the DXF data into the VEC data
using the attached software "Logo Data Conversion Software".
4 DELETE :
Press [DELETE] to delete the setting of the logo file.
If there is no logo file setting, the logo condition is not saved at file saving.
5 Origin (only for DXF file format) :
Specifies the coordinate of the origin point for DXF file data.
Select from center, lower left, lower right, upper left, upper right or as original graphic.
6 X/Y Position :
X/Y position of the reference point of the logo file data.
Setting Range
Reference
• For the coordinate definition of 3D figures, refer to "Coordinate System (World Coordinate / Local Coordinate)" (P.135) .
7 Rotation Angle :
Sets the rotation direction of the logo file data.
Setting Range
4
0 to 99
-330.000 mm to +330.000 mm
-180.00 to +180.00 degree
ME-LPMSZ-OP-7
„ DXF File Format
1
3
11
5
12
6
13
7
14
9
10
15
2
4
155