Figure 43: Placing The Bumper Foot On A Base Corner Hole; Figure 44: Inserting The Rivet Into The Bumper Foot - Allied Telesis x950 Series Installation Manual

3. Place the bumper foot onto one of the holes in the base of the switch.
Refer to Figure 43.
Figure 43. Placing the Bumper Foot on a Base Corner Hole
4. Insert the rivet to secure the bumper foot to the base. Refer to
Figure 44.
Figure 44. Inserting the Rivet into the Bumper Foot
5. Repeat steps 2 to 4 to install the remaining bumper feet.
6. Turn the switch over and place it on a flat, secure desk or table, leaving
ample space around it for ventilation.
x950 Series Installation Guide for Stand-alone Switches
89