Figure 20: Placing The Bumper Foot On A Base Corner Hole; Figure 21: Inserting The Rivet Into The Bumper Foot - Allied Telesis x530 Series Installation Manual

3. Place the bumper foot with rivet housing onto one of the holes in the
base of the switch. Refer to Figure 20.
Figure 20. Placing the Bumper Foot on a Base Corner Hole
4. Insert the rivet to secure the bumper foot to the base. Refer to
Figure 21.
Figure 21. Inserting the Rivet into the Bumper Foot
5. Repeat steps 2 to 4 to install the remaining bumper feet.
6. Turn the switch over and place it on a flat, secure desk or table, leaving
ample space around it for ventilation.
7. After placing the switch on the table or desktop, go to "Powering On
the Stack" on page 91.
x530 Series Installation Guide for Virtual Chassis Stacking
65