Figure 10: Inserting The Assembled Rivets Into The Hole In The Foot; Figure 11: Placing The Feet With Rivets On The Switch; Figure 12: Attaching The Rubber Feet To A Switch - Allied Telesis AT-x220-28GS Installation Manual

Chapter 2: Installation
24
4. Insert the rivet through the hole in the feet as shown in Figure 10 on
page 24.
Figure 10. Inserting the assembled rivets into the hole in the foot
Insert all assembled rivets into the holes in the feet
5. Place the feet with the rivet inserted into the base holes on the switch.
Figure 11. Placing the feet with rivets on the switch
6. Push the feet firmly into holes on the base of the switch so that the
rivets lock the feet in place as shown in Figure 12 on page 24
Figure 12. Attaching the rubber feet to a switch
7. Turn the switch over again and place it on a flat, secure surface (such
as a desk or table), leaving ample space around the unit for ventilation.