Figure 19: Inserting The Rivet Housing Into The Bumper Foot; Figure 20: Placing The Bumper Foot On A Base Corner Hole - Allied Telesis x530L Series Installation Manual

Note
The following procedure assumes that you have already reviewed
the information and performed the procedures in Chapter 2,
"Beginning the Installation" on page 45.
To install the switch on a table, perform the following procedure:
1. Place the switch upside down on a table.
2. Inset a rivet housing into a bumper foot. Refer to Figure 19.
Figure 19. Inserting the Rivet Housing into the Bumper Foot
3. Place the bumper foot with rivet housing onto one of the holes in the
base of the switch. Refer to Figure 20.
Figure 20. Placing the Bumper Foot on a Base Corner Hole
4. Insert the rivet to secure the bumper foot to the base. Refer to Figure
21 on page 58.
x530L Series Installation Guide for Stand-alone Switches
57