Reset Command - Siemens SINUMERIK 840D sl Function Manual

K1: Mode group, channel, program operation, reset response
9.9 Program operation
Possible actions in the interrupt state
Various functions can be performed in the channel during a part program interruption, for
example:
● Overstore
References
Operating Manual, HMI Advanced, Section "Machine operating area" > Automatic mode"
> "Overstore"
● Block search
References
Function Manual, Basic Functions; Section "Mode group, channel, program operation, reset
response (K1)" > "Block search" or "Block search type 5 SERUPRO"
● Repositioning (REPOS)
References Function Manual, Basic Functions; Section "Mode group, channel, program
operation, reset response (K1)" > "Block search type 5 SERUPRO" > "REPOS" >
"Repositioning with controlled REPOS"
● Oriented tool retraction
References
– Programming Manual, Job Planning; Section "Tool offsets"
– Description of Functions, Basic Functions; Section "Tool offsets (W1)" > "Orientable
● Interrupt routine (see Section "Asynchronous subprograms (ASUBs), interrupt routines
(Page 558)")
● DRF function, offset of the workpiece zero
References
Function Manual, Extended Functions; Manual and Handwheel Travel (H1)
● Starting the interrupted program via:
– START command from another channel
– NC/PLC interface:
9.9.4

RESET command

Command priority
Channel status
The RESET command can be executed in every channel state. This command is aborted by
another command.
532
toolholders" > ""
References
Programming Manual, Job Planning; Section "Flexible NC programming" > "Program
coordination (INIT, START, WAITM, WAITMC, WAITE, SETM, CLEARM)"
DB21, ... DBX7.1 (NC start)
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions