P3: Basic PLC program for SINUMERIK 840D sl
13.16 Basic conditions and NC VAR selector
Maximum configuration (2 channels, 4 spindles, 4 axes, T MCP)
see above
Compile cycles
13.16
Basic conditions and NC VAR selector
13.16.1
Supplementary conditions
13.16.1.1
Programming and parameterizing tools
Hardware
For the PLCs used in SINUMERIK 840D sl, the following equipment is required for the
programming devices or PCs:
Processor
RAM (MB)
Hard disk,
free capacity (MB)
Interfaces
Graphic
Mouse
Operating system
The required version of STEP 7 can be installed on equipment meeting the above requirements
in cases where the package has not already been supplied with the programming device.
900
Total
Minimum
Pentium
256
500
MPI, Ethernet incl. cable
Memory card
SVGA (1024*768)
Yes
Windows 2000 /XP Professional, STEP 7 version 5.3 SP2 or
higher
Recommendation
Pentium
512 or more
> 500
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
436
59822
Basic Functions