P
/reset
1 s
P
/reset
<3 s
P
Β
Note:
For meaning of the error and diagnostic codes, see chapter Error code list...
When an error has been acknowledged, it can still be read out from the error history.
Building Technologies
13.4.1.4.
Fault status messages, display of errors and info
Display of errors (faults) with lockout
V
h min s
%
Reset
V
h min s
%
V
h min s
%
Basic Documentation LME7...
13 Operation via AZL2
Display shows Loc:. The bar under the fault status
message
appears.
Unit is in the lockout position.
The current error code is displayed (see chapter Blink
code table).
Example: Error code 7
When pressing
for 1 second, rESEt appears on the
/reset
display.
When the button is released, the basic unit is reset.
When pressing
for
/reset
InFo, SEr and then OPErAtE.
When the button is released, the basic unit is reset.
3 seconds, the display shows
>
59/106
CC1P7105en
17.04.2018