P3: Basic PLC program for SINUMERIK 840D sl
13.17 Block descriptions
13.17.4.6
PI service: DIGION
Function: Digitizing on
Selecting digitizing in the parameterized channel.
Description of formal parameters
Signal
PIService:
Unit:
13.17.4.7
PI service: DIGIOF
Function: Digitizing off
Deactivating digitizing in the parameterized channel.
Description of formal parameters
Signal
PIService:
Unit:
13.17.4.8
PI service: FINDBL
Function: Activate block search
A channel is switched to search mode and the appropriate acknowledgement then transmitted.
The search is then executed immediately by the NC. The search pointer must already be in
the NC at this point in time. The search can be interrupted at any time by an NC RESET. Once
the search is successfully completed, the normal processing mode is reactivated automatically.
NC start then takes effect from the located search target.
It is the sole responsibility of the operator to ensure a collision-free approach path.
Description of formal parameters
Signal
PIService:
Unit:
WVar1:
944
Type
Value range
ANY
"PI".DIGION
INT
1, 2, 3 ... 10
Type
Value range
ANY
"PI".DIGIOF
INT
1, 2, 3 ... 10
Type
Value range
ANY
"PI".FINDBL
INT
1 to 10
WORD
1, 2, 3
Description
Digitizing on
Channel
Description
Digitizing off
Channel
Description
block search
Channel
Preprocessing mode
1: Without calculation
2: With calculation
3: With main block consideration
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions