M Function With An Implicit Preprocessing Stop; Response To Overstore - Siemens SINUMERIK 840D sl Function Manual

8.11

M function with an implicit preprocessing stop

Function
Triggering a preprocessing stop in conjunction with an auxiliary function can be programmed
explicitly via the STOPRE part program command. Always triggering a preprocessing stop in
M function programming can be parameterized for each M function via the following machine
data:
MD10713 $MN_M_NO_FCT_STOPRE[<n>] (M function with preprocessing stop)
Example
The user-defined M function M88 is intended to trigger a preprocessing stop.
Parameter assignment:
MD10713 $MN_M_NO_FCT_STOPRE [ 0 ] = 88
Application:
Parts program (extract)
Program code
...
N100 G0 X10 M88
N110 Y=R1
...
Boundary conditions
If a subroutine called indirectly via an M function in a part program in one of the following ways,
no preprocessing stop is performed:
● MD10715 $MN_M_NO_FCT_CYCLE (M function to be replaced by subroutine)
● M98 (ISO dialect T / ISO dialect M)
8.12

Response to overstore

Overstore
On the SINUMERIK operator interface, before starting the following functions:
● NC START of a part program
● NC START to resume an interrupted part program
the auxiliary functions that are output at the start can be changed by the "Overstore" function.
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Comment
; Traversing motion and implicit preprocessing stop via M88
; N110 is only interpreted after the traversing motion has
been completed and the M function has been acknowledged.
H2: Auxiliary function outputs to PLC
8.12 Response to overstore
417