Siemens SINUMERIK 840D sl Function Manual page 872

P3: Basic PLC program for SINUMERIK 840D sl
13.10 Structure and functions of the basic program
Relevant parameters (FB1)
MCP device identification
Direct keys such as e.g. OP 08T, OP 12T
IdentMcpType (Mcp-Type)
no device connected
MCP 483C IE (Compact)
MCP 483C IE
MCP 310
MCP OEM
MCP DMG
HT 8
TCU_DT (direct keys)
MCP_MPP
HT 2
OP 08T (direct keys)
PROFIBUS connection on the DP port (MCPBusType = 3)
In case of PROFIBUS connection of the MCP, this component must be considered in the
hardware configuration setting of STEP 7. The MCP is connected to the standard DP bus of
the PLC (not to MPI/DP). The addresses must be stored in the input and output log range.
These start addresses must also be stored in the pointer parameters of the FB1. The FB1
parameters listed below are used for further parameterization.
There is no PROFIBUS version of the HHU. For this reason, an Ethernet connection is shown
for the HHU in this figure. The PROFIBUS slave address must be stored in the parameters
"MCP1BusAdr" and "MCP2BusAdr". Enter the pointer to the configured diagnostic address
(e.g. P#A8190.0) in "MCPxStatRec".
872
Input parameters, e.g. OP 08T
B#16#1
0
B#16#80
B#16#81
B#16#82
B#16#83
B#16#84
B#16#85
B#16#86
B#16#87
B#16#88
B#16#89
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions