Pi Service: Tmpcit; Pi Service: Tmrass; Pi Service: Tresmo - Siemens SINUMERIK 840D sl Function Manual

P3: Basic PLC program for SINUMERIK 840D sl
13.17 Block descriptions
13.17.4.28

PI service: TMPCIT

Function: Set increment value for workpiece counter
Incrementing the workpiece counter of the spindle tool
Description of formal parameters
Signal
PIService:
Unit:
WVar1:
WVar2:
13.17.4.29

PI service: TMRASS

Function: Resetting the tool status "active"
The PI service sets the status to "inactive" for all of the tools with a tool status "active" or
"blocked".
The following events are sensible times for resetting the tool status:
● a negative edge of the NC/PLC interface signal "tool disable ineffective"
● End of program
● Channel reset.
The PI service is intended mainly for the PLC, since it is known here when the disabled tool
is finally no longer to be used.
Description of formal parameters
Signal
PIService:
Unit:
13.17.4.30

PI service: TRESMO

Function: Reset monitoring values
This PI service resets the monitoring values of the designated edges of the designated tools
to their setpoint (initial) values.
This is only performed for tools with active monitoring.
See also the RESETMON command.
958
Type Value range
ANY "PI".TMPCIT
INT 1, 2, 3 ... 10
WORD 0, 1, 2 ... max.
WORD 0 ... max.
Type Value range
ANY "PI". TMRASS
INT 1, 2, 3 ... 10
Description
Set increment value for workpiece counter
TOA
Spindle number; corresponds to the type index in
the location data with "Spindle" location type of the
buffer magazine in channel.000 = main spindle
Increment value; indicates the number of spindle
revolutions after which the workpiece counter is in‐
cremented
Description
Reset active status
TO area
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions