Reset Command - Siemens SINUMERIK 802D sl Function Manual

Execution of command
After execution of the STOP command, IS "Program status stopped" (V3300 0003.2) and the
IS "Channel status interrupted" (V3300 0003.6) are set. Processing of the interrupted part
program can continue from the point of interruption with another START command.
The following actions are executed when the STOP command is triggered:
● Part program processing is stopped at the next block limit (with NC stop at block limit,
● Any auxiliary functions of the current block not yet output, are no longer output.
● The axes are stopped with subsequent stop of the part program processing.
● The block indicator stops at the point of interruption.
10.3.4

RESET command

Function
The RESET command (IS "Reset" (V3000 000.7)) can be executed in every channel state.
This command is aborted by another command.
A RESET command can be used to interrupt an active part program or part program blocks.
After execution of the Reset command, IS "Channel status reset" (V3300 0003.7) and the IS
"Program status aborted" (V3300 0003.4) are set.
The part program cannot be continued at the point of interruption. All axes in the channel are
at exact stop.
The following actions are executed when the RESET command is triggered:
● Part program preparation is stopped immediately.
● All axes and if appropriate spindles are braked.
● Any auxiliary functions of the current block not yet output, are no longer output.
● The block indicator is reset to the beginning of the part program.
● All alarms are cleared from the display if they are not POWER ON alarms.
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
M0/M1 or single block), processing is stopped immediately with the other STOP
commands.
Operating Modes, Program Operation (K1)
10.3 Processing a part program
175