Siemens SINUMERIK 840D sl Function Manual page 756

K2: Axis Types, Coordinate Systems, Frames
10.5 Frames
Scalings of the virtual axis are taken over.
Example:
Machine data for TRAANG:
; FRAME configurations
$MC_MM_SYSTEM_FRAME_MASK = 'H1'
$MC_CHSFRAME_RESET_MASK = 'H41'
$MC_CHSFRAME_POWERON_MASK = 'H41'
$MN_FRAME_GEOAX_CHANGE_MODE = 1
$MC_RESET_MODE_MASK = 'H4041'
;$MC_RESET_MODE_MASK = 'H41'
;$MC_GCODE_RESET_VALUES[7] = 2
$MC_GCODE_RESET_VALUES[7] = 1
$MN_MM_NUM_GLOBAL_USER_FRAMES = 0
$MN_MM_NUM_GLOBAL_BASE_FRAMES = 3
$MC_MM_NUM_USER_FRAMES = 10
$MC_MM_NUM_BASE_FRAMES = 3
$MN_NCBFRAME_RESET_MASK = 'HFF'
$MC_CHBFRAME_RESET_MASK = 'HFF'
$MN_MIRROR_REF_AX = 0
$MN_MIRROR_TOGGLE = 0
$MN_MM_FRAME_FINE_TRANS = 1
$MC_FRAME_ADD_COMPONENTS = TRUE
; TRAANG is 1st transformer
$MC_TRAFO_TYPE_1 = 1024
$MC_TRAFO_AXES_IN_1[0] = 4
$MC_TRAFO_AXES_IN_1[1] = 3
$MC_TRAFO_AXES_IN_1[2] = 2
$MC_TRAFO_AXES_IN_1[3] = 0
$MC_TRAFO_AXES_IN_1[4] = 0
$MC_TRAFO_GEOAX_ASSIGN_TAB_1[0]=4
756
; SETFRAME
; Frames are active after RESET.
; Frames are deleted for "Power On".
; Frames are calculated after switchover
of the geo axis.
; Basic frame is not deselected after RE-
SET.
; Basic frame is deselected after RESET.
; G54 is the default setting.
; G500 is the default setting.
; from 5 to 100
; from 0 to 8
; No scaling when mirroring.
; Fine offset
; G58, G59 is possible.
; Inclined axis
; Axis is parallel to z
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Basic Functions