11.12 Deactivating block mode
Required master media:
Block-Master
l
The Program-Master must first be authorised for the locking device on which it is to be
used, see
"Authorising additional master media"
Procedure:
1. Hold the Block-Master before the reading field of the locking device.
After ca. 2 second, the following signal appears:
2x short green
2. Remove the Block-Master from the reading field of the locking device.
The blocking mode is now deactivated. An access with an authorised locking media is now possible
again.
Troubleshooting:
Signalling
A higher-priority opening mode is cur-
rently active (see
ing modes"
on page 84).
The Block-Master is not authorised.
Long shield ILS
Reason
Deactivate the
"Hierarchy of the open-
opening mode with higher priority.
Authorise the
Block-Master
11.12 Deactivating block mode
on page 111
Solution
Page125 of 141