4.5 Assembling basic version (for Long shield holes)
4.5 Assembling basic version (for Long shield holes)
4.5.1 Scope of delivery Long shield ILS basic version
1
1 Outside fitting, pre-assembled with outside lever handle, coupling module and e-module
2
1 Assembly plate, pre-assembled with inside lever handle
3
1 Inside shield
4
1 Fixture ring
5
1 Square spindle
6
3 Washers (for fixing screws)
7
3 Locking nuts (for fixing screws)
8
2 Fixing screws without cable slit (with fixing rings)
9
1 Fixing screw with cable slit (with fixing ring)
10
2 Batteries Energizer Ultimate Lithium 1,5V AA
11
1 Battery module
12
1 Support frame
13
1 Spring clip (only for handle sets without a PZ hole)
14
1 Installation tube
4.5.2 Assembling Long shield ILS basic version
The reading side of the fitting is assembled on the outside of the door; the non-reading side is
assembled on the inside.
The handle set cannot be assembled on split follower locks!
Page 20 of 141
Long shield ILS