Activating Release Mode - CEStronics CES OMEGA FLEX Assembly And Operating Instructions Manual

11.9 Activating release mode

11.9 Activating release mode

A locking device which is in release mode remains permanently coupled, i.e. the door can be
opened permanently without necessitating the use of any locking media.
Required master media:
Release-Master
l
The Program-Master must first be authorised for the locking device on which it is to be
used, see "Authorising additional master media"
Procedure:
1. Hold the Release-Master before the reading field of the locking device.
After ca. 1 second, the following signal appears:
1x short green
If the locking device already lights up green while the Release-Master is being read, but no
green flashing signal appears after one second, release mode is already active.
2. Remove the Release-Master from the reading field of the locking device.
The release mode is now active. Permanent access without locking media is now possible because
the coupling of the locking device is permanently engaged. The release mode has no time limit.
Altered signalling in release mode: In release mode, the locking device signals 1x long green
(instead of 1x short green) after reading from an authorised locking media.
Troubleshooting:
Signalling
A higher-priority opening mode is currently act-
ive (see "Hierarchy of the opening modes"
page 84).
The Release-Master is not authorised.
Page 122 of 141
on page 111
Reason
b) Deactivate the opening mode with the
on higher priority.
Authorise the Release-Master.
Solution
Long shield ILS