Activating Block Mode - CEStronics CES OMEGA FLEX Assembly And Operating Instructions Manual

11.11 Activating block mode

11.11 Activating block mode

A locking device in block mode remains permanently uncoupled, i.e. the door cannot be opened.
An access even with an authorised locking media is no more possible.
Required master media:
Block-Master
l
The Program-Master must first be authorised for the locking device on which it is to be
used, see "Authorising additional master media"
Procedure:
1. Hold the Block-Master before the reading field of the locking device.
After ca. 1 second, the following signal appears:
1x short green
If the locking device already lights up green while the Block-Master is being read, but no
green flashing signal appears after one second, block mode is already active.
2. Remove the Block-Master from the reading field of the locking device.
The block mode is now active. An access is not possible now even with an authorised locking media
because the coupling of the locking devise is permanently disengaged. The block mode has no time
limit.
Using an Emergency-Key, a locking device can still be opened in block mode.
Troubleshooting:
Signalling
A higher-priority opening mode is cur-
rently active (see
ing modes" on page 84).
The Block-Master is not authorised.
Page 124 of 141
Reason
b) Deactivate the opening mode with the
"Hierarchy of the open- higher priority.
Authorise the
Block-Master
on page 111
Solution
Long shield ILS