Switching The Edge Cutter On And Off - DURKOPP ADLER 550-12-33 Operating Instructions Manual

Operation
Operating Instructions 550-12-33/34 - 00.0 - 08/2017

4.16 Switching the edge cutter on and off

CAUTION
Risk of injury at exposed blade!
There is a risk of sustaining injuries at the
exposed blades.
Do not reach into the cutting area.
Class 550-12-34 is equipped with an edge cutter. The edge cutter
is switched on and off using the button (1) on the OP3000 control
panel.
In manual mode, the edge cutter can be switched on and off at
any time ( p. 66). The top blade is designed such that it will
penetrate reliably even if activated during sewing.
Fig. 38: Switching the edge cutter on and off
①
(1) - Upper softkey
To switch the edge cutter on:
1. Press the upper softkey (1)
To switch the edge cutter off:
1. Press the upper softkey (1)
Information
The upper softkey (1) can also be assigned a different function.
In this case, the edge cutter can also be switched on and off in
the softkey menu ( p. 70).
.
.
55