Programming
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Sewing with ruffling
1.
Release the pedal (position 0).
2.
To select the ruffling type if necessary, press the
•
: Ruffling top and bottom
•
: Ruffling top
•
: Ruffling bottom
The set ruffling value is shown on the display.
3.
If necessary, use the numeric buttons 0 – 16 to change the
ruffling value.
The set ruffling value is shown on the display below the
ruffling type.
4.
Press the pedal forward to position 1 and continue sewing.
The seam will be sewn using the altered parameter value.
Adjusting parameters during sewing
To adjust parameters during sewing:
1.
Release the pedal (position 0).
2.
Change the desired parameter on the control panel (( p. 68)).
3.
Press the pedal forward to position 1 and sew.
The seam will be sewn using the altered parameter value.
Finishing sewing
To finish a seam:
1.
To finish the seam, press the pedal completely backwards to
position -2.
The machine stops.
Needle and sewing feet are lifted and remain up as long as
the pedal is kept in the -2 position.
2.
Cut the reinforcement tape at the thread-pulling knife ( p. 59).
3.
Remove the sewing material.
button.
73