Table of Contents
Advertisement
Setup
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Erecting the machine head
To erect the machine head:
1.
Grab the machine at the machine arm and erect it carefully.
The tilt sensor detects the erected position and unlocks the
machine. The machine is ready to sew again.
Information
The tilt sensor is composed of the tilt sensor found on the machine
head and a permanent magnet housed inside the tabletop cutout.
Both parts have been pre-assembled at the factory.
The machine remains locked if the tilt sensor is not fully assembled
or defective.
While the tilt sensor can be deactivated on the OP3000, deacti-
vation is not recommended ( p. 120).
149
Advertisement
Table of Contents
