Switching On Or Off The Edge Cutter; Selecting A Program - DURKOPP ADLER 275 Series Operating Instructions Manual

Programming
Operating Instructions 275 - 02.0 - 08/2019
5.1.7

Switching on or off the edge cutter

On machines with an edge cutter, this must be enabled for every
sequence and for smooth sewing ( p. 46).
To switch on the edge cutter:
1. In the sequence before the start of sewing, press the
button .
 The green LED above the button lights up.
The edge cutter is activated.
To switch off the edge cutter:
2. Press the buton
 The green LED above the button goes out.
The edge cutter is deactivated.
5.1.8

Selecting a program

After the machine is switched on, the current program is displayed
briefly.
A program consists of a series of sequences, each of which having
a particular upper transport value.
The sequences are processed consecutively from 1 to 8. Individual
sequences can be deactivated but the sequences cannot be
assigned more than once and their consecutive positions cannot
be changed.
To select a program:
1. Press and hold the button
 The current program number is displayed briefly.
The LED above the button
are in the program selection function.
The sewing drive is not ready for operation during program
selection.
2. Set the desired program number using the
again.
and also press the button
flashes to indicate that you
.
buttons.
57