Table of Contents
Advertisement
120
5.9.8
Setting the contrast of the display
You can adjust the contrast of the display on the OP3000 control
panel as needed.
To adjust the contrast of the display:
1.
Open the User configuration menu ( p. 114).
▲/▼
2.
Use
to select the Contrast parameter.
3.
Confirm with OK.
4.
Change the value using the
5.
Confirm with OK.
6.
To exit service mode, press the ESC button.
The changed value is stored immediately.
5.9.9
Activating/deactivating the tilt sensor
WARNING
Risk of injury from moving, cutting and sharp
parts!
Crushing, cutting and punctures are possible.
Only qualified specialists may deactivate the tilt
sensor.
Do not deactivate the tilt sensor unless for good
reason and re-activate it as soon as possible.
Exercise special caution when working on the
machine with the tilt sensor deactivated
Do not press the pedal while the machine head
is tilted back.
The tilt sensor serves as a safety device. It senses when the
machine head is tilted and subsequently locks the machine.
Sewing is not possible during this time. This feature prevents the
pedal from being actuated inadvertently while the machine head
is tilted back, e.g. for maintenance and repairs.
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Programming
▲/▼
buttons.
Advertisement
Table of Contents
