Table of Contents
Advertisement
6.17 Sewn material edge trimmer control
6.17.1 Switching on/off edge trimmer
3
B
2
1
A
Switch on
–
Push the knob (1) in the arrow (A) direction, or pull the handle (2) in
the arrow (B) direction until the trimming knife gets from the initial
position (3) to the switch on position (4).
–
Trimming mechanism drive starts up automatically when switched
on, and the trimming knife starts oscillating. The mechanism is
ready to trim (e.g. a lining) simultaneously with stitching.
–
When trimming the edge, direct the trimmed material under the
knife collar (5).
Switch off
–
Push the knob (1) downwards. The trimming knife turns from the
switched on position (4) to the initial position (3) and the trimming
mechanism drive switches off automatically.
Setting: see service instructions
5
4
1
GB
31
Advertisement
Table of Contents
