Assigning The Edge Cutter To The Knee Button (680 Only) - DURKOPP ADLER 670 Operating Instructions Manual

Programming
Operating Instructions 670/680 - 00.0 - 01/2017
Information
Use the button to switch to the parameter value: the param-
eter for the knee button is t 51 28.
4. Use the buttons + or - to set the numerical value to the desired
value.
• Upper fullness: 39
• Lower fullness: 40
5. To save the settings, press the buttons
5.2.2 Assigning the edge cutter to the knee button
(680 only)
To assign the edge cutter to the knee button:
1. Press the
2. Press the knee button to the desired position (down).
3. Keep the knee button pressed for 1 second.

flashes.
The display shows a numerical value.
Information
Use the button to switch to the parameter value: the param-
eter for the knee button is t 51 28.
4. Use the buttons + or - to set the numerical value to the desired
value.
• Edge cutter: 36
5. To save the settings, press the buttons
button.
and
.
and
.
53