DURKOPP ADLER 550-12-33 Operating Instructions Manual page 181

Troubleshooting
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Code Type Possible causes
6351 Error Control defective
– (I²C)
6354
6360 Warning Data on machine ID
not permissible
6361 Warning Machine ID not
connected
6362 Error Internal EEprom
–
6367
6400 Error Internal error
–
6999
7551 Error • Internal error
– • Cable disturbance
7659 • Cables to the
9310 Error • CAN connector not
• Tape unwinder
9320 Error • Tape unwinder dirty
• Tape unwinder
9910 Error Tilt sensor:
• Machine head is
• Tilt sensor not
control panel
Interface defective
connected or faulty
faulty
faulty
tilted over
assembled or
defective
Remedial action
• Replace control
• Replace control
• Check the connection of
the machine ID cable
• Replace the machine ID
• Replace control
• Replace control
• Switch off and on the
machine
• Perform a software update
• Contact Customer Service
• Switch off and on the
machine
• Eliminate source of
disturbance
• Perform a software update
• Replace cable
• Contact customer service
• Replace CAN connector
• Replace tape unwinder
• Replace control
• Clean tape unwinder
• Open throttle valve
• Replace tape unwinder
• Erecting the machine
head
• Fit or replace tilt sensor
179