Table of Contents
Advertisement
Setup
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Proper setting: 10° inclination with pedal (3) released
The pedal (3) is assembled to the cross strut (2). You can adjust
the position of the pedal (3) as needed by moving it using the cross
strut.
The pedal (3) must also be tilted to a degree that allows the
operator to move the pedal forward and backward without a
problem.
To set the position of the pedal:
1.
Loosen the wing nuts (1) on the left and the right of the cross
strut ends (2).
2.
Slide the cross strut (2) that holds the pedal (3) forward or
backward.
3.
Tighten the wing nuts (1) on the left and the right of the cross
strut ends (2).
4.
Slightly loosen the 2 screws (4) on the pedal rod.
Fig. 91: Setting the pedal (2)
5.
Pull the pedal rod to the correct length.
When in the rest position, the pedal (3) must be bent 10° at
the front.
6.
Tighten the 2 screws (4) on the pedal rod.
10°
145
Advertisement
Table of Contents
