Table of Contents
Advertisement
82
The machine counts down the programmed stitches while
sewing and will NOT stop automatically when all stitches
have been sewn. The machine keeps sewing for as long
as the pedal is kept in the 1 position. The stitches sewn and
indicated on the display are preceded by a minus sign.
4.
To finish the seam, press the pedal completely backwards to
position -2.
The machine stops and returns to the beginning of the seam
program/to the other side (if the left and the right side are
sewn one after the other).
Needle and sewing feet are lifted and remain up as long as
the pedal is kept in the -2 position.
5.
Cut the reinforcement tape at the thread-pulling knife ( p. 59).
6.
Remove the sewing material.
5.4.4
Canceling a seam program in automatic mode
To cancel a seam program in automatic mode:
1.
Press the pedal fully back to position -2.
The machine remembers the spot where sewing was
interrupted. The seam program will resume from this
position when sewing continues.
2.
To cancel the seam program completely, press the pedal
completely backwards to position -2 again.
The seam program is canceled.
Operating Instructions 550-12-33/34 - 00.0 - 08/2017
Programming
Advertisement
Table of Contents
