Switches - Xilinx KC705 User Manual

Chapter 1: KC705 Evaluation Board Features
Table 1-27: GPIO Connections to FPGA U1 (Cont'd)
4-Pole DIP Switch
User Rotary Switch
User SMA

Switches

[Figure
The KC705 evaluation board includes a power and a configuration switch:
•
•
Power On/Off Slide Switch SW15
[Figure
The KC705 board power switch is SW15. Sliding the switch actuator from the Off to On
position applies 12V power from J49, a 6-pin mini-fit connector. Green LED DS22
illuminates when the KC705 board power is on. See
onboard power system.
54
Send Feedback
U1 FPGA Pin Schematic Net Name
G12
AB7
Y29
W29
AA28
Y28
Y25 ROTARY_INCB SW
AA26 ROTARY_PUSH SW
Y26 ROTARY_INCA SW
Y23 USER_SMA_GPIO_P
Y24 USER_SMA_GPIO_N
1-2, callout 27 - 28]
Power on/off slide switch SW15 (callout 27)
FPGA_PROG_B SW14, active-Low (callout 28)
1-2, callout 27]
Caution!
Do NOT plug a PC ATX power supply 6-pin connector into J49 on the KC705 board
The ATX 6-pin connector has a different pinout than J49. Connecting an ATX 6-pin connector into
J49 will damage the KC705 board and void the board warranty.
www.xilinx.com
GPIO_SW_C
CPU_RESET
GPIO_DIP_SW0
GPIO_DIP_SW1
GPIO_DIP_SW2
GPIO_DIP_SW3
Power Management
I/O Standard GPIO Pin
LVCMOS25 SW5.1
LVCMOS15 SW7.1
LVCMOS25 SW11.4
LVCMOS25 SW11.3
LVCMOS25 SW11.2
LVCMOS25 SW11.1
LVCMOS25 SW8.6
LVCMOS25 SW8.5
LVCMOS25 SW8.1
LVCMOS25 J13.1
LVCMOS25 J14.1
for details on the
KC705 Evaluation Board
UG810 (v1.6.2) August 26, 2015