Interfaces (Eth[1]); Interfaces (Eth[1]) > Config; Interfaces (Eth[1]) > Status - ADTRAN Total Access 600R System Manual

Section 4 User Interface Guide
I (T1[0]) > T
NTERFACES
Indicates whether a test is in progress.
I (ETH[1])
NTERFACES
View the Ethernet interface status and configure the Ethernet parameters from this menu.
The 1 in ETH[1] represents a physical port. The Ethernet physical port is always 1.
I (ETH[1]) > C
NTERFACES
Enable the
A
UTONEGOTIATION
I (ETH[1]) > C
NTERFACES
If set to ,
O A
N UTONEGOTIATION
setting. is the default setting.
O
N
I (ETH[1]) > C
NTERFACES
(This option is only available if
interface. Choices are
10B
I (ETH[1]) > C
NTERFACES
(This option is only available if
interface for
F D
ULL UPLEX
simultaneously.
H D
ALF
but not simultaneously. The default is
If the
D
ATA
F D
ULL UPLEX
I (ETH[1]) > S
NTERFACES
Displays the
MAC A
DDRESS
I (ETH[1]) > S
NTERFACES
This is a read-only field which displays the unique MAC address programmed at ADTRAN.
I (ETH[1]) > S
NTERFACES
Displays the status of the data link as up or down. This is a read-only field.
68
> T S
EST EST TATUS
ONFIG
and configure the Ethernet rate from this menu.
> A
ONFIG UTONEGOTIATION
automatically detects 10 or 100 Mb Ethernet and negotiates the duplex
> D
ONFIG ATA
A
UTONEGOTIATION
and
T 100B T
ASE ASE
> D
ONFIG UPLEX
A
UTONEGOTIATION
or .
H D F
ALF UPLEX ULL
allows the Ethernet interface to either send or receive at any given moment,
UPLEX
H D
ALF UPLEX
is set to
R 10B
ATE ASE
or .
H D
ALF UPLEX
TATUS
, ,
D L D
ATA INK ATA
> MAC A
TATUS
> D
TATUS ATA
© 2002 ADTRAN, Inc.
R
ATE
is set to .)
O D
FF ATA
. The default value is
10B
T
YPE
is set to .)
O D
FF UPLEX
allows the Ethernet interface to send and receive
D
UPLEX
.
or , the
T 100B T D
ASE
, and
R D T
ATE UPLEX YPE
DDRESS
L
INK
Total Access 600R System Manual
sets the speed of the Ethernet
R
ATE
.
T
ASE
configures the Ethernet
T
YPE
must be configured as
T
UPLEX YPE
.
61200600L1-1A