ADTRAN Total Access 600R System Manual page 130

Section 5 DLP-001
Perform Steps Below in the Order Listed
1. Connect a VT100 terminal to the unit.
• Set the parameters of the VT100 terminal to:
– 9600 baud rate
– 8 data bits
– No parity
– 1 stop bit
– No flow control
• If the terminal has a parallel setting, disable it and use serial port.
• Plug the RJ-45 male end of the data cable into the CRAFT port on the rear of the unit by
using the ADTRAN-proprietary DB-9 to RJ-45 adapter. Make the connection to the VT100
terminal as appropriate for your equipment.
2. Connect a PC emulating a VT100 terminal to the unit.
3. Most personal computers or laptops can run communications software that will emulate a VT100
terminal. Windows programs such as Terminal
Windows format. However, there are many other adequate, commercially available software packages
which will allow your PC or laptop to emulate a VT100 terminal. Certain configuration items must be
set on a PC or laptop for it to act as a VT100 terminal for the unit.
• Set the PC for direct connect on the appropriate com port (instead of dial-up connection).
• Set the parameters of the communications software to:
– 9600 baud rate
– 8 data bits
– No parity
– 1 stop bit
– No flow control
• Plug the RJ-45 male end of the data cable into the CRAFT port on the rear of the unit by
using the ADTRAN-proprietary DB-9 to RJ-45 adapter. Make connection to the PC or lap-
top as appropriate for your equipment.
4. Press <Enter> or <Ctrl + R> until the Login menu appears on screen.
You are now ready to log in to the unit, as described in DLP-002, Logging in to the System.
A VT100 terminal program is provided with the ADTRAN Utilities.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
130
DLP-001
©
or Hyperterminal
© 2002 ADTRAN, Inc.
Total Access 600R System Manual
©
are two such examples in the
61200600L1-1A