ADTRAN Total Access 600R System Manual page 93

Total Access 600R System Manual
R > C > R
OUTER ONFIG
Use this menu to enter static routes to other networks.
N
UM
Displays the index number in the static route table.
A
CTIVE
Adds this static route entry to the IP routing table when set to
added) if set to
N
O
IP A
DDRESS
The IP address of the host or network address of the device being routed to. Default is
S M
UBNET ASK
Determines the bits in the previous IP address that are used. If this is to be a host route, it must be set
to all ones (255.255.255.255). Default is
G
ATEWAY
The IP address of the router to receive the forwarded IP packet. Default is
H
OPS
The number of router hops required to get to the network or host. Maximum distance is 16 hops.
Default is .
1
P
RIVATE
When set to , the unit will advertise this static route using RIP. Setting to
N
O
is kept private. Default is
R > C > DHCP S
OUTER ONFIG
Use this menu to set up the DHCP server.
R > C > DHCP S
OUTER ONFIG
When set to , the unit acts as a DHCP server and will dynamically assign IP, network mask, default
O
N
gateway, and DNS addresses to any device which transmits a broadcast DHCP request. The addresses
assigned are based on the unit's own IP address and will be within the same network. Default is
61200600L1-1A
> S R
OUTES TATIC
. Default is .
N
O
0.0.0.0
.
N
O
ERVER
> DHCP M
ERVER
© 2002 ADTRAN, Inc.
OUTES
and removes it (if it was previously
Y
ES
.
ODE
Section 4 User Interface Guide
0.0.0.0
0.0.0.0.
means that the route
Y
ES
O
.
.
FF
93