ADTRAN Total Access 600R System Manual page 136

Section 5 DLP-003
Perform Steps Below in the Order Listed
1. Connect to the unit using either the 10/100B
If you are not already connected to the unit's
VT100 compatible terminal or with a PC running VT100 emulation software), follow the procedure in
DLP-001 Connecting the Terminal or PC to the CRAFT Port.
Alternately, if the unit is part of a management cluster connected to the local network, you may use a
PC connected to the network to Telnet into the unit. Use the procedures in DLP-004 and DLP-006
to connect to the
10/100B
2. Log in to the unit.
Log in to the unit (see DLP-002, Logging in to the System for details).
3. Go to the S C
YSTEM
4. Go to the T A
ELNET
5. Go to the A M
UTHEN
The choices are P
ASSWORD
6. Go to the U L
SER IST
7. To add a new user profile and password, right arrow over to the right pane.
8. Give the new user profile a name by selecting the N
defined name.
9. Personalize the password for the appropriate level by selecting the P
then typing the desired password. You will have to type the new password again to confirm it.
Passwords for the unit are case sensitive. There is no default password for a new user (i.e., you can
configure a user as blank with no password). The current password displays as a series of asterisks
(********).
10. Select the I T
DLE IME
the session may be idle before the user is logged off. The range is 1-255. The default value is 10.
11. Assign the password level by selecting the L
descriptions.
136
interface.
T
ASE
menu and select the M
ONFIG
menu and press <Enter>.
CCESS
menu and press <Enter>. Select the appropriate authentication method.
ETHOD
, R , P
ADIUS ASSWORD
menu and press <Enter>.
( ) field and press <Enter>. This field defines the amount of time in minutes
MINS
© 2002 ADTRAN, Inc.
DLP-003
T or CRAFT interfaces.
ASE
interface (either with a
CRAFT
menu and press <Enter>.
ANAGEMENT
/R , and R
ADIUS ADIUS
field, pressing <Enter>, and typing the user
AME
field and choosing from the following level
EVEL
Total Access 600R System Manual
/P .
ASSWORD
field, pressing <Enter>,
ASSWORD
61200600L1-1A