ADTRAN Total Access 600R System Manual page 158

Section 5 DLP-009
Perform Steps Below in the Order Listed
Saving Configuration using TFTP Server on Local Network
1. Connect to the unit using the 10/100B
If you are not already connected to the unit's
procedure in DLP-006, Telnetting to the Unit, to connect to the unit.
2. Verify the TFTP server is running on the network.
A TFTP server ships as part of the ADTRAN utilities. If using ADTRAN utilities, choose
S >P
TART
3. Go to the S U
YSTEM
4. Verify the T
RANSFER
5. Set the TFTP S
ERVER
Program.
If you are using the ADTRAN TFTP server, the IP address displays in the S
For other TFTP servers, please refer to the appropriate documentation.
6. Change TFTP S
ERVER
saved to the remote server. An example filename would be ta_iad.cfg.
Some TFTP servers constrain the format of the filename depending on the operating system of the
server. For example, a TFTP server running on a PC under Windows 3.1 may only permit 8.3 format
filenames (8 characters, period and three extension characters).
7. Select the S C
AVE ONFIG
Enter to confirm the request.
Y
158
DLP-009
T interface.
ASE
>ADTRAN U
ROGRAMS
menu and select the C
TILITY
M is set to TFTP.
ETHOD
IP A to the IP address of the machine running the TFTP Server
DDRESS
F to a unique filename. This will be the name of the configuration file
ILENAME
R menu field and press <Enter>.
EMOTELY
© 2002 ADTRAN, Inc.
Total Access 600R System Manual
port using Telnet client software, use the
10/100B T
ASE
>TFTP S
TILITIES ERVER
T
ONFIGURATION RANSFER
to start the server.
menu; press <Enter>.
field.
TATUS
61200600L1-1A