ADTRAN Total Access 600R System Manual page 146

Section 5 DLP-006
Perform Steps Below in the Order Listed
1. Connect the computer to the unit's CRAFT port as shown in DLP-001, Connecting the Terminal or PC
to the CRAFT Port.
2. Log in to the unit as shown in DLP-002, Logging in to the System.
3. Select S C
YSTEM ONFIG
4. Right arrow to A
UTHEN
R /P
ADIUS ASSWORD
5. Verify the T A
ELNET
The following screen will appear.
6. Use the right arrow key to select the N
Telnet logins.
7. If P was selected for the A
ASSWORD
<Enter>. Enter a password to be used for Telnet logins.
8. Use the right arrow key to select I
in minutes the Telnet session may be idle before the user is logged off. The range is 1-255. The
default value is 10 minutes. Enter the appropriate I
9. Use the right arrow key to select L
definitions, reference DLP-003 Adding/Removing Telnet Users and Changing Password Security
Levels.
10. This completes the addition of one Telnet user. Repeat Steps 1-9 for each user needing Telnet
access.
146
, M , and T
ANAGEMENT
M and press <Enter>. Select P
ETHOD
and press <Enter>.
is set to O . Down arrow to select U
CCESS N
AME
UTHEN
T (
DLE IME
. Select the appropriate security level. For security level
EVEL
© 2002 ADTRAN, Inc.
DLP-006
A .
ELNET CCESS
ASSWORD
SER
field; press <Enter>. Enter a username to be used for
M in Step 4, right arrow over to P
ETHOD
); press <Enter>. This field defines the amount of time
MINS
T .
DLE IME
Total Access 600R System Manual
, R , P
ADIUS ASSWORD
L and press <Enter>.
IST
ASSWORD
61200600L1-1A
/R , or
ADIUS
; press