ADTRAN Total Access 600R System Manual page 84

Section 4 User Interface Guide
The Ethernet port will always appear in the
regardless of the L2 Protocol mode setting.
R > C > I
OUTER ONFIG
The Ethernet sub-interface is 802.3[1.0]. The [1.0] represents the Ethernet physical and logical ports,
where 1 is the physical port and 0 is the logical port assigned to the Ethernet interface. This is a read-only
field.
R > C > I
OUTER ONFIG
Configure the Ethernet addressing, RIP, and Proxy ARP from this menu.
P IP
RIMARY
This is used to set up the IP addresses for the LAN on the unit.
IP A
DDRESS
The IP address assigned to the unit's Ethernet port is set here. This address must be unique within
the network. Default is
S M
UBNET ASK
This is the IP network mask that is to be applied to the unit's Ethernet port. Default is
255.255.255.0.
RIP
Use this menu to enable RIP on the LAN interface.
V
ERSION
Enables or disables RIP and specifies the RIP Protocol. Choices are;
RIP), (RIP Version 1) or
V1
M
ETHOD
Specifies the way the RIP Protocol sends out its advertisements. The following options are
available:
S
PLIT
P
OISON
84
(ETH[1]) > S
NTERFACES
(ETH[1])> S
NTERFACES
.
10.0.0.1
(RIP Version 2). The default is
V2
H (DEF) Only routes not learned from this circuit are advertised.
ORIZON
R All routes are advertised, but the routes learned from this port
EVERSE
are "poisoned" with an infinite metric.
© 2002 ADTRAN, Inc.
Total Access 600R System Manual
R > C
OUTER ONFIG
-I
UB NTERFACE
ETUP
O
table
> I
NTERFACES
(which disables
O
FF
.
FF
61200600L1-1A