ADTRAN Total Access 600R System Manual page 123

Total Access 600R System Manual
Router T1 Interface Setup Instructions - IP Routing with NAT
Step
The
1
The
The T1 interface will not appear if a DLCI is not entered in the DLCI mapping table (
P
ROTOCOL
Frame Relay (FRE).
From the NAT menu, set P
2
and populate the corresponding
Set P
•
3 •
For basic
For specific port translations or 1:1 mapping, you can enter T
From the T
4
enter the table.
Create specific
P
UBLIC
P
UBLIC
P
ROTOCOL
P
UBLIC
P
UBLIC
5
P
UBLIC
P
RIVATE
P
RIVATE
P
RIVATE
T
RANSLATE
61200600L1-1A
NAT
menu is found under
NAT
menu can be easily accessed by pressing <Ctrl><N>.
T1[0]-FRE > C
ONFIG
ORT
IP A M
UBLIC DDRESS ODE
is the default and will use the WAN IP address for the NAPT address.
I
NTERFACE
allows you to enter another public address for private addresses to be
S
PECIFIED
translated into.
NAT
, this is all of the configuration that needs to be done.
T
RANSLATION ABLE
NAT
translations based on your application.
A M NAPT A
DDRESS ODE
the NAPT address or specifying a different public
address to be used for this translation.
NAPT A
A M
DDRESS ODE
the NAPT address or specifying a different public
address to be used for this translation.
Protocol for this translation.
P M S
ORT ODE
the P
settings.
P Numeric Public Port number to be translated (e.g., 23,
ORT
80).
P T Read-only port type chosen by the user setting of the
ORT YPE
P
A M S
DDRESS ODE
up the P
P M S
ORT ODE
the P
P Numeric Private Port number to be translated to (e.g. 23,
ORT
80).
B Y
ODY
data packet and replace the private address with the
NAPT address. Default is N
applications.
© 2002 ADTRAN, Inc.
Action
R >C >I
OUTER ONFIG NTERFACES
> DLCI
) when the L2 Protocol is set to
MAPPING
to E
T
RANSLATION NABLED
NAT
menu options.)
to either I or S
NTERFACE PECIFIED
menu, create a new entry by using the right arrow to
(Address) or S
DDR
(Address) or
DDR
or A P . Choosing S
PECIFIED NY ORT
P and P
UBLIC ORT UBLIC
P option.
UBLIC ORT
or A I
PECIFIED NY NTERNAL
A option.
RIVATE DDRESS
or A P . Choosing S
PECIFIED NY ORT
P option.
RIVATE ORT
or N . If set to Y , this will translate the body of the
ES O
ES
Section 4 User Interface Guide
(T1 [0]) > S
ETUP
L2
. (This will enable translation
.
[+].
T
RANSLATION ABLE
. Choice of using
PECIFIED
S
. Choice of using
PECIFIED
brings up
PECIFIED
P T (read-only)
ORT YPE
. Choosing S brings
PECIFIED
brings up
PECIFIED
, which is used for most
O
.
123