ADTRAN Total Access 600R System Manual page 150

Section 5 DLP-007
Perform the Steps Below in the Order Listed
1. Connect to the unit using the CRAFT interface.
If you are not already connected to the unit's
VT100 compatible terminal or with a PC running VT100 emulation software), follow the procedure in
DLP-001, Connecting the Terminal or PC to the CRAFT Port. Connecting to the
its the upgrade procedure to XMODEM Only.
2. Log in to the unit.
Log in to the unit (see DLP-002, Logging in to the System for details).
3. Go to the S U
YSTEM
4. Go to the T
RANSFER
5. Select S T
TART RANSFER
6. From the terminal emulation software, begin the XMODEM upload by using the appropriate command
sequence. If necessary, refer to the terminal emulation software documentation for help.
Also, when specifying the filename, ensure that the file transferred is the one provided by ADTRAN.
Otherwise, the update will not complete successfully. This may take several minutes.
Because XMODEM data is being transferred in-band through the menu interface, the VT100 menus of
the unit will be inoperable from the
terminal emulation software. (Please consult the documentation provided by the terminal emulation
software to determine how to do this.)
7. When the update has successfully completed, the following messages will display:
Verifying downloaded FLASH image...
Erasing FLASH...
Programming FLASH...
FLASH programmed successfully.
The unit will restart immediately, and the user may then log back into the system.
Alternately, if the unit is part of a management cluster connected to the local network, you may use a
PC connected to the network to Telnet into the unit. By utilizing the
be quickly upgraded using TFTP provided there is a TFTP server on the local network. The unit can
also be upgraded across the WAN using TFTP provided there is a TFTP server accessible to the unit.
The unit ships with ADTRAN Utilities software, which includes a TFTP server. See DLP-008,
Upgrading the Firmware Using TFTP, for more details.
150
DLP-007
menu and select the U
TILITY
M menu and select XMODEM.
ETHOD
to start the update. Enter Y to confirm the upgrade.
CRAFT
© 2002 ADTRAN, Inc.
interface (either with a
CRAFT
F
PGRADE IRMWARE
interface. You can cancel the update at any time within the
Total Access 600R System Manual
interface lim-
CRAFT
menu; press <Enter>.
port, the unit may
10/100B T
ASE
61200600L1-1A