L2 Protocol (T1[0]) > Protocol; L2 Protocol (T1[0] - Ppp); L2 Protocol (T1[0] - Ppp) > Config - ADTRAN Total Access 600R System Manual

Section 4 User Interface Guide
L2 P (T1[0]) > P
ROTOCOL
Configure the L2 Protocol mode. Choices are
enables the Auto-config feature. Reference DLP-014, Unit Installation Using The Auto-Config Feature,
for more information.
L2 P (T1[0]) > P
ROTOCOL
Point-to-Point Protocol (PPP) is an 8-bit serial protocol which allows a PC to connect as a TCP/IP host to a
network through an asynchronous port. PPP is used for connection from a PC to an Internet Service
Provider (ISP) for Internet access. PPP works over synchronous and asynchronous circuits.
Router-to-router and host-to-network connections can be made via PPP. PPP includes error detection while
Serial Line Internet Protocol (SLIP) and other protocols do not.
L2 P (T1[0]) > P
ROTOCOL
Frame Relay is a switched data link layer protocol that handles multiple virtual circuits using High-Level
Data Link Control (HDLC) encapsulation. Frame Relay uses statistical multiplexing as opposed to
time-division-multiplexing to multiplex many logical connections over a single physical link. It contains a
cyclic redundancy check (CRC) for detecting bad data, but leaves the error correction algorithms to be
performed by the higher protocol layers. Similarly, Frame Relay uses simple congestion notification. This
notification in turn can alert higher-layer protocols to exercise flow control. These characteristics allow
Frame Relay to provide a more flexible and efficient use of bandwidth.
L2 P (T1[0]) > P
ROTOCOL
Setting the
L2 P
ROTOCOL
network.
The
L2 P
DLP-014, Unit Installation Using The Auto-Config Feature, for more information.
L2 P (T1[0] - PPP)
ROTOCOL
Configure the
L2 P
ROTOCOL
this menu.
L2 P (T1[0] - PPP) > C
ROTOCOL
Configure the
L2 P
ROTOCOL
L2 P (T1[0] - PPP) > C
ROTOCOL
Select the
L2 P
ROTOCOL
Default is .
R IP
OUTE
70
ROTOCOL
PPP
> PPP
ROTOCOL
> FRE
ROTOCOL
> A
ROTOCOL UTO
to allows the unit to automatically detect the
A
UTO
must be set to
ROTOCOL
parameters and view the status of the T1 interface using PPP protocol from
ONFIG
parameters for the T1 interface using PPP protocol.
> M
ONFIG
mode. Choices are
R
OUTE
© 2002 ADTRAN, Inc.
Total Access 600R System Manual
, , and . The default is
FRE A
UTO
in order to use the Auto-config feature. Reference
A
UTO
ODE
, , and
IP B A
RIDGE LL
. Selecting
A
UTO
from the
L2 P
ROTOCOL
R IP/B O
OUTE RIDGE THER
61200600L1-1A
A
UTO
. The