ADTRAN Total Access 600R System Manual page 156

Section 5 DLP-008
Prior to the start of the upgrade, the transfer status will display
status messages display in T
these messages.
Message
Transferring... [X KB] Indicates communication with the TFTP network server has been
Flash Programmed
Successfully
Loaded code
ver x.x.x
chksum = xxxx
Resetting....
RECV Error
Host Timeout
idle
8. When the update has successfully completed, F
in the T S
RANSFER TATUS
message. Finally the T
The unit will restart immediately and resume operation. After giving the unit sufficient time to reboot,
the user may Telnet back into the unit and log in.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
156
S
RANSFER TATUS
established and the update file is being transferred between the unit and
the TFTP network server.
The unit has been upgraded successfully.
Unit displays the version and checksum of the upgraded code.
Unit is power cycling.
Unit will display this message if server filename is incorrect.
Unit will display this message if TFTP server address is incorrect.
The upgrade has not yet been initiated.
field. This will be followed by a L
S field will display R
RANSFER TATUS
© 2002 ADTRAN, Inc.
Total Access 600R System Manual
. During the TFTP upload, various
I
DLE
to indicate progress. The following table describes
Meaning
P S
LASH ROGRAMMED UCCESSFULLY
C
OADED ODE VER X
...
ESETTING
will display briefly
. . C =
X X HKSUM XXXX
61200600L1-1A